|
|
Targets
LASERGUIDE uses six retro-reflective targets to establish the tool
XYZ position relative to each projector.
Assembly Guidance calls
this process "registration." Six targets offer the optimum balance of
registration accuracy and registration time. The operator initially
steers the laser beam near each target position, then clicks the
"register" button. The system goes to each steered-to position and
finds the exact location of the targets. Typical tolerance on the
location of targets is 0.001" (0.025mm.)
|
Specification:
- Target accuracy: 0.0005"
- Target angle: flat, 45 or 90 degrees
- Target spot size: 0.125" or 0.25"
- Target offset: 0.3125" or 0.5"
- Shank diameter: 0.25"
|
|
|
|
|
