No walking back and forth between tool and control computer
Uninterrupted display
All LASERGUIDE Projectors are “Plug and Play” with any controller in any configuration. (No special files or file editing required)
Superior Performance Fabricators who have attempted to use other laser vendor’s multitasking often ask:
Why is it so complicated to run a part”?
“Why do these projections stop all the time when they’re not associated with another job that is stopping”?
“Why is the system so slow to respond”?
“Why do our operators have to walk to the computer all the time”?
These problems and inefficiencies do not occur with LASERGUIDE multitasking.
From the beginning, all LASERGUIDEMultitasking (introduced in 1994) has supported multiple remotes, billboards, and any projector used in any configuration-at any time. Multiple LASERGUIDE remote controls on a single system support all layup functions as well as providing graphics that could only be seen on the control computer with other systems.
Operators with experience with Assembly Guidance multitasking, as well as the partial multitasking supplied by other laser vendors, prefer LASERGUIDE. Unlike some other multitasking systems, an engineer is not needed to assist layup operators in running the LASERGUIDE system.
Specification:
Simultaneous open data files: 8
Remote controls per system: 8
Remote control functions:
Main Page: Next, Previous, Idle, Redisplay, Steer, Next Part
(control a different part with this remote)
Text display for ply or part/system status
Clear targets, show last targets, steer and fine steering
Ply list (scrolling) and graphic display of ply shape
“All functions, for all parts,
controlled from the tools”
AssemblyGuide.com copyright 2008 Reproduction in whole or any form or medium without express written
permission of
Assembly Guidance Systems, Inc. is strictly prohibited and punishable by law.
